top of page

SHOP

Before you print any of my 3D Printed models .. or even before you buy one of my 3D printed models, please download the free ”Information Pack” and “Cura Settings” for my settings and preferences for printing LW-PLA in spiral mode and run a few tests to configure your printer .. Information Pack
PLEASE NOTE: ALL MY 3D PRINTED MODELS ARE DESIGNED TO BE PRINTED USING CURA SILCER

If you decide to slice the models yourself, it is SO important that you stick as close as possible to my recommendations and Cura profiles

otherwise your prints are going to fail

It is important that you download the “Information Pack” and do a few test prints before you start (preferably before you purchase)

The fuselage and wings are designed to be printed from active foaming LW-PLA “ColorFab LW-PLA” or “e-Sun PLA-LW”, either will work

The fuselage formers and other parts are designed to be printed from PLA+

My 3D printed "Quick Build" models are single wall double skin design with infill between the 2 walls 
These models are very quick and easy to build once the parts are printed and can be printed on any 3D printer with a print volume size of 220 x 220 x 220 or larger. 
The filament I use (and recommend) for these models is LW-PLA (active foaming Light Weight PLA)
E-sun PLA-LW, ColorFabb LW-PLA or PolyLight 1.0 all print about the same and can be used 
I supply STL and G-code files with all 3D printed designs and most printers (not Bambu Lab printers) will accept my G-codes, but if your printer does not accept my G-codes then it will be necessary for you to slice the STL files yourself .. I ONLY use Cura slicer for my designs, but I have no doubt other slicers can be used to slice the STL files
Please download a Test File free of charge and do a test print before you purchase one of my "Quick Build" models

bottom of page